Get 10% off Shapr3D with promo code TheOffCut10 Check it out! https://www.shapr3d.com/ Also check out The Good Rule and support NZ small businesses: https://thegood.nz/ This is what I consider the most efficient layout of my workshop for the work that I do. The main issue for me is storing and managing full sheets of plywood to turn into furniture. It is what I would consider a near perfect setup for me. Yes, it gets very messy very quick. And yes, it gets very cramped in here at times. But it forces me to be smart with my processes and be as efficient as possible. _______________________________________________ My Tools: Dewalt table saw: https://amzn.to/3ackejR Mirka Deros Sander: https://amzn.to/3e7CXAq Makita track saw: https://amzn.to/3D7QXVp Festool CT15 Shopvac: https://amzn.to/3xytwla Countersink bit: https://amzn.to/33KaXOK Music/Ear protection: https://amzn.to/3fKEb2l Camera: https://amzn.to/31P9sfN Router: https://amzn.to/2PFz5tu Pocket hole jig: https://amzn.to/3a9E3s0 Mechanical pencil: https://amzn.to/3acH9LH CA Glue: https://amzn.to/2NvFE49 (Get 15% off using promo code "OFFCUT15" at https://www.starbond.com/?rfsn=2960183.4fc3a) _______________________________________________ Get my plans: https://gumroad.com/theoffcut Merch: https://teespring.com/stores/the-offcut Instagram: https://www.instagram.com/theoffcut_nz Facebook: https://www.facebook.com/theoffcut Support me on Patreon: https://www.patreon.com/theoffcut