Now, when the dental implant is angulated like this, you would need to put an angulated dental abutment to correct the angulation of the dental implants. In this case, we want to use straight multi-units because we had an angulated multi-unit with an angulated implant and very low gingiva. For angulated multi-units, you almost always have a problem with the aesthetical aspect if it's in the frontal area, because the buccal part of the angulated implant is almost always visible when you don't have enough height of the gingiva. Visit Uniqa Dental site https://bit.ly/3jHZGoq 00:00 We can have a fully functional, beautiful crown to correct the angulation of the implant when you don't have enough height of the gingiva. 00:31 We restored the left upper part of the patient, and we had one implant that was placed a really long time ago. 01:38 This is probably PMMA. It's a temporary bridge. 01:47 You have two molars, two premolars and the canine. 02:27 The antagonist is the same way. She can't have a fully new crown 03:30 3 implants and one where the molar is. 04:05. It's a V-type multi-unit. 05:01 The dental implant is angulated 06:20 That's how you fix this problem? 07:54 Having small screw channels is better than having the regular bulk here 08:33 This way we close the screw channels with pins, temporary pins. 09:16 This distribution of forces is very good for this stopper. 09:49 Are there any downsides to using the stopper? 10:12 So, it all depends on the distribution of those... 10:29 In this case, we had one implant that was placed a very long time ago. 11:27 It is in great condition. #screwretainedrestoration #cadcam #Digitalimpression